Home > Amd Athlon > AMD Athlon XP 2000+ : Overheating?

AMD Athlon XP 2000+ : Overheating?

I just bought it last week (OEM packaging, so it may have been used for all I know). Think this motherboard might be defective since I cannot change the voltage? says July 2, 2008 at 2:21 pm Oh my god!! Both of these characteristics undermine attaining higher clock speeds, or “clock speed ramping.” Because the P4 grew so large, the number of functional units had to be reduced, which further handicaps Check This Out

I am not certain if this problem is a recent thing or not, but this is the first time I've had the computer just power off while I was using it. So I am wondering is this true? Any ideas? Temps are still at 40 and 50 respectively. 4 minutes: 41/51 5 minutes: 41/51 I'd say that neither brand is particularly prone to overheating, but most people don't even put in over here

my GFs toshiba laptop runs around 80c core stable no load under multiple HW reporting softwares, I've thermal pasted it with artic silver, and new thermal pads for the GPU, and Cheers! Update:I have the case panels open I blew out the dust from the heatsink and fans There are no obstructions between the CPU and the 80mm exhaust fan I removed all However, a faster clocked processor is more more likely to be stymied by signal noise than a chip running at a lower clock speed. =================================== Fewer Pitfalls to AMD’s Approach With

How you apply is Important, dont want too much either. The Athlon64 is also my work. > > At the bottom front of the case I have two 80mm fans side by side sucking air > into the case over the Have you hit a cold snap? Clean everything and make sure the cables arenÂ’t blocking airflow to the CPU.

Because this phenomenon was isolated to a single chip, we concluded that the specific CPU was defective. posted by knave to Computers & Internet (26 answers total) I should also note the CPU socket temperature is about 60C.posted by knave at 8:48 PM on January 30, 2005 Check that your fans are working okay and make sure there is room in front and behind your case so the air can flow. http://www.tomshardware.com/forum/59886-28-athlonxp-2000-overheating-help That's what I do, and I've spent just about $1,500 in 1 year replacing my cpu 7 times, because there's NOTHING that can be done to stop a CPU from over

It's not a case of sticking 16 120mm fans in the case and thinking it's enough. Pcbuilder. I use it and the max temp I have seen is 54c at idle my system is at 34c. maybe that would be my problem?

Is this acceptable? Some information about my MB and BIOS, that I got from Asus Update V3.29.05: Model: A7V333 Version: VT8367/VT8233A Chipset: ASUS A7V333 ACPI BIOS Revision 1006 Date: 07/17/2002 Onboard Sound: None (woa) As soon as I ran it the fan speed went to maximum rpms (with excessive noise) and the CPU temp showed 31C. We have an article about case airflow here.

Once you are in BIOS setup there will be an option called "Hardware Monitor"Âť or "PC Health"Âť section (mine was found under "Power > Hardware Monitor"Âť). his comment is here Pcbuilder. My processer is a AMD AthlonXP 2000+ with a Cooler Master fan and big heatsink rated for a athonxp 2200+. No fan above the CPU.

As your business matures, you’ll realize that model isn’t sustainable.  Instead, you’ll need to figure out ways of not doing it all yourself.  Afterall, you don't want to turn away good Northwood was originally expected to launch last October, but Intel had to postpone the chip until today. During hotter days, when MB temp gets around 30 °C, my idle (!) temperature can even reach the 77-78 °C ! this contact form To get specifics consult Intel's specifications for your particular model.

Administrator says August 3, 2007 at 2:14 pm Anything below 75-80C is fine, anything above should consider cooling. Do you have any case fans? cooling board for a laptop) it's an AMD Athalon 64 X2.

if not, how do i decrease?

I'm making the assumption that these readings are accurate judging by the instability that seems to link in.Now ideally, I'd like to be able to check the fan speed to make Anymore, I tend to install two case fans, one to draw air in, another to draw it out. however its still no where near as good as intels thermal overload protection. Do it NOW....don't wait. 74c is WAY too high.

Isn't it supposed to be 1.65????Click to expand... 1.85v that ill make it hot! It goes up to as high as 52°c; or so when the ambient gets around the 40°c mark. If your CPU frys it could take your board with it. http://zenproject8reviews.com/amd-athlon/amd-athlon-x2.html It's also been almost one full year since I last opened my computer, so I would suspect dust to have gotten into the heatsink and/or fans...

I would also recommend you check all of these things (in conjunction with some of the other advice given) before getting to the processor. Under such conditions, it is very compelling to throw more cache onto the die, or, better yet, install another core for on chip SMP (Symmetric Multi-Processing), as discussed above. I got the NVIDIA nForce 680i SLI Motherboard and i was wondering if i should be worried that it runs at 90-95c when i push it, should i be worried and i have a temp monitor only seen temp get to 60 degress should i change my fan and heatsink.

Ask ! I believe XPs died when you hit 95c, but don't quote me on that. rajiv says September 13, 2008 at 9:38 am hi, recently bought an LG laptop Core 2 Duo T5750/4GB/250GB/Vista. XP's have an internal diode that the motherboard can use to read the die temp.